(Obsolete) Saftronics VG10 – Dynamic Torque Vector AC Drive
(Obsolete FINCOR Series 6600)

• Saftronics VG10 – Dynamic Torque Vector AC Drives
• Pricing, Dimensions & Weights
• Optional DC Link Reactors
• Options & Accessories
  • Palm Pilot Saflink Kit
  • Relay Output Card
  • SR10 Radio Modem Kit
  • Digital I/O Interface Card
  • Analog I/O Interface Card
  • SF-10 Ethernet Module
  • PGX Encoder Feedback Card
  • Encoder + Analog Output Card
  • PG Feedback Card (VG10 only)
  • PG Feedback Card (VG10 only)
  • Synchronized Operation Card (VG10 only)
  • 24 VDC or 24/120 VAC Interface Card Kit (PC10, GP10 or VG10 Inverter)
  • Air Pressure Sensor + V/I Converter Output Card
• SDBU – Dynamic Brake Module
  • 208-230V Dynamic Brake Packages
  • 460V Dynamic Brake Packages
• Ratings Efficiency & Watts Loss (230, 460VAC)
• Standard Specifications
• For Drive Dimension Sheets, contact Joliet Technologies
  • DC Link Reactor 100 HP and Above
• Basic Connection Diagrams
  • Basic Connection Diagram (Sink Logic, Mainly America)
  • Basic Connection Diagram to PLC (Sink Logic, Mainly America)
  • Basic Connection Diagram (Source Logic, Mainly Europe)
  • Basic Connection Diagram to PLC (Source Logic, Mainly Europe)
• For Spare Parts, contact Joliet Technologies

Options & Accessories

Name	PG Feedback Card (VG10 only)
Part Number	SOPCG11SPG
Function	To perform speed control by detecting motor rotating speed using a pulse generator.
Specifications	Control Speed Control Range 1 : 1200 RPM (3 to 3600r/min) Maximum speed 3600 r/min (120 Hz) Speed Control accuracy +/-0.02% Speed Control response 40 Hz Applicable encoder (generator) No. of output pulses:100 to 3000 P/R AlB phase (incremental) Maximum response frequency: 100 kHz Pulse output method: Totem pole / open collector. Output current 7mA or more. Input Terminal VA, VB, CM Connect A- and B-phase output signal from pulse generator on feedback side. YZ, CM Connect Z-phase output signal from pulse generator on feedback side. When the pulse generator does not have Z -phase, these terminals need not be connected. Output Power Source None – Internal Power Source: +15 VDC +/- 10% 120mA, + 12 VDC +/- 10% (Changeable on PC board1) (Terminal: PO, CM) – External Power Source: +12 VDC (-10%) to +15 VDC (+1%) / 300mA or less2) (Terminal P1, CM.
Connection Diagram

Remarks: Terminals XA, XB, and XZ are not in use.

{1) Use external power source when more than one PG feedback cards are used and the total input current exceeds 120mA
(2) Take note of the power source matches the specifications of the applied pulse generator.